Интегрированное проектирование и анализ переменного и постоянного тока
Управляемые модели SCADA, EMS, PMS, ADMS и SAS
Интеллектуальные Контроллеры и Система Управления
Единая платформа цифрового двойникаПроектирование, эксплуатация и автоматизация
Filter by
Didn't find what you are looking for? We're here to help!
280 Item(s) found
ETAP Transmission Line Sag and Tension Analysis module is an important tool to perform sag and tension calculation for transmission and distribution lines to ensure adequate operating condition for the lines.
ETAP Star provides intelligent tools and powerful capabilities to analyze system protection and troubleshoot false trips, relay and breaker mis-operation, mis-coordination, and more.
ETAP Transformer Sizing software provides a comprehensive tool for sizing of the transformer MVA rating and impedance for 1-phase and 3-phase, two-winding transformers, based on ANSI/IEEE and IEC standards.
Advanced distribution reliability assessment provides engineers with an efficient and effective tool for estimating the performance of power systems.
The ETAP Parameter Estimation program calculates equivalent circuit model parameters for machines at starting condition.
The Optimal Power Flow module solves power system load flow, optimizes system operating conditions, and adjusts control variable settings, while ensuring system constraints are not violated.
Optimal Capacitor Placement allows engineers to strategically place capacitors for voltage support and power factor correction while minimizing installation and long-term operation costs.
With ETAP’s Harmonic Analysis module, you can identify harmonic problems, reduce nuisance trips, design and test filters, and report distortion limit violations.
Ground Grid Systems module enables engineers to quickly and accurately design and analyze ground protection.
Using full frequency-dependent machine and network models, the Generator Start-Up module analyzes cold-state starting of generators under normal and emergency conditions.
ETAP seamlessly integrates the analysis of power and control circuits within one electrical analysis program. The Control System Diagram (CSD) simulates the sequence-of-operation of control devices such as solenoids, relays, controlled contacts, multi-sequence contacts, and actuators including inrush conditions.
Cable Pulling Analysis accounts for multiple cables of different sizes and allows complex 3D pulling path geometry.
This presentation will provide an insight on the justification, objectives, and implementation of SCADA, DMS and OMS integrated system using ETAP ADMS solution at the NPCL Utility in India.
ETAP provides a comprehensive, integrated design and analysis solution for electric power systems. This webinar will highlight several study cases to demonstrate the software’s capabilities in LV system modeling for cable capacity, sizing and protection against electric shock, as well as reporting and project deliverables.
Learn how to size passive single-tuned filters as part of harmonic analysis.
ETAP GRID™ is the most comprehensive enterprise solution for design, simulation, operation, control, optimization, and automation of generation, transmission, distribution, and microgrid power systems.
In this presentation we showcase the hardware-in-the-loop simulation testing procedure of one of ETAP’s real-time smart grid solutions, AGC (Automatic Generation Control). The ability of AGC to respond to varying operating conditions on the grid is demonstrated and the set-up enables testing under several “what-if” scenarios.
This datacenter 101 presentation explores how ETAP is being used to design a power system in a data center, how power was performed inside the data center, provides an overview of the project the collaboration with ETAP and summaries what lessons were learned in the process.
ElectroMagnetic Transient Program - EMTP
Assess system for greatest improvement at minimum cost with ETAP's Reliability Assessment.