Resource Center

Prime content - login required
SQA

SQA

ETAP ArcFault™ - High Voltage Arc Flash Analysis

ETAP ArcFault™ - High Voltage Arc Flash Analysis

ETAP ArcFault™ software is recommended for performing Arc Flash Analysis on electrical utilities and renewable power systems operating at 15 kV and above.

ETAP Arc Flash IEEE 1584-2018

ETAP Arc Flash IEEE 1584-2018

ETAP Arc Flash Analysis software is used to perform arc flash analysis for systems from 0.208 kV to 15 kV in accordance with IEEE 1584-2018 “IEEE Guide for Performing Arc Flash Hazard Calculations.” The software determines the incident energy and arc flash boundary values required to comply with NEC equipment labeling. It also provides hazard evaluation for shock protection and arc flash PPE according to NFPA 70E 2018.

ETAP DC Arc Flash Session Part 1-3

ETAP DC Arc Flash Session Part 1-3

30:00

The topics discussed in this video are the characteristics of an Arc, DC Short Circuit calculations, the Maximum Power Method, the Stokes and Oppenlander Method, Paukert Method, how these methods are utilized in ETAP, the calculation of incident energy, how to configure ETAP 11.1 to determine whether or not you are dealing with an open or closed air equipment, and the result analyzer.

ETAP Arc Flash Overview Part 1-6

ETAP Arc Flash Overview Part 1-6

1:00:00

ETAP Arc Flash Analysis automatically estimates the Incident Energy released in the event of an arc fault and determines the required Flash Protection Boundary.

ETAP 19 Installation Guide

ETAP 19 Installation Guide

ETAP 19 Installation Guide and System Requirements.
Easy to follow instruction on how to install ETAP Software

20 of 502 results